Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Side Turn Signal Light Assembly: Inspection
- Apply battery voltage between the connector terminals to check the lighting condition of the light.CAUTION:
When applying battery voltage, do not mix up the positive (+) side and the negative (-) side.Β
Incorrect polarity connection may cause internal LED damage.Β
Terminal No. Inspection conditions Specification 1 (+) - 2 (-) Apply battery voltage. Light ON - Replace the light assembly side turn mirror if faulty is found in the inspection.NOTE:
Since LED is used for the light, replace the light assembly side turn mirror if the light does not illuminate.Β
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
