Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE
Room Light: Inspection
WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
- Measure the resistance between connector terminals.
Terminal No. Inspection conditions Standard 1 - 3 Switch OFF 1 MΞ© or more Switch ON Less than 1 Ξ© 2 - 3 Switch door Less than 1 Ξ© - Apply battery voltage between the connector terminals to check the lighting condition of the light.
Terminal No. Inspection conditions Specification 3 (+) - 1 (-)
3 (+) - 2 (-)Switch OFF Light OFF Switch ON Light ON Switch door Light ON - Replace the light assembly roof if faulty is found in the inspection.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.