WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.

When performing service operation, refer to "Repair Contents" in "General Description". Ref. to REPAIR CONTENTS>REPAIR CONTENTS
When performing work on the sensors or modules, be careful of the following.
- Before disconnecting electrical connectors, be sure to disconnect the ground terminal from the battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY
- Do not apply any impact. If the parts are accidentally dropped, replace with a new part.
- Do not expose to high-temperature and humidity.
When replacing the parts provided with memory functions, record the memory contents before disconnecting the ground terminal from the battery sensor.
Refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION
Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.
Always replace with a bulb that is the same model and wattage as those of the old one.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Section 7 (Lighting System): General Description: Caution

Use the Manual With the Right Hardware

When to See a Mechanic