Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE
Electrical Specification
WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
| Terminal No. | Contents | Measuring condition | Standard |
|---|---|---|---|
| (B78) No. 1 (+) ββ (B78) No. 2 (-) | Battery power supply | Always | 8 - 16 V |
| (B78) No. 2 ββ Chassis ground | GND | Always | Less than 1 Ξ© |
| (B78) No. 3 (+) ββ (B78) No. 2 (-) | Ignition power supply | When ignition switch is ON | 8 - 16 V |
| (B78) No. 4 | - | - | - |
| (B78) No. 5 | - | - | - |
| (B78) No. 6 ββ Chassis ground | Leveling actuator power supply | Ignition switch ON | 8 - 16 V |
| (B78) No. 7 ββ Chassis ground | Leveling actuator GND | Always | Less than 1 Ξ© |
| (B78) No. 8 | - | - | - |
| (B78) No. 9 ββ Chassis ground | Leveling actuator signal | Headlight off β on | Less than 1 V β 1.0 - 14.4 V (for 17 seconds) |
| Headlight on, no vehicle height change β change and hold vehicle height for 3 seconds or more | |||
| (B78) No. 10 | - | - | - |
| (B78) No. 11 ββ (B78) No. 2 | LH headlight malfunction signal | When the headlight illuminates | When normal: 1 Ξ© or less When faulty: 1 MΞ© or more |
| (B78) No. 12 ββ (B78) No. 2 | RH headlight malfunction signal | When the headlight illuminates | When normal: 1 Ξ© or less When faulty: 1 MΞ© or more |
| (B78) No. 13 | LIN communication signal | - | Communication line |
| (B78) No. 14 | LIN communication GND | - | Communication line |
| (B78) No. 15 | CAN-H | - | Communication line |
| (B78) No. 16 | CAN-L | - | Communication line |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
