2021 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Electronically-Controlled Damper Model

WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the front wheels. Ref. to WHEEL AND TIRE SYSTEM>TIRE AND WHEEL>REMOVAL .
  3. Remove the electric damper harness ABS assembly front.
    CAUTION:
    • Be careful not to damage the sensor.Β 
    • Do not apply excessive force to the sensor harness.Β 
    1. Disconnect the connector of the electric damper harness ABS assembly front in the engine compartment.
      G14602123Courtesy of SUBARU OF AMERICA, INC.
    2. Disconnect connectors.
    3. Remove the bolts, the harness clip, and the grommet, and remove the electric damper harness ABS assembly front.
G14602124Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.