Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE
Section 30 (Engine Intake System (Induction)): Turbocharger: Assembly
WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
- Install the stud bolt using TORX® E10.
Tightening torque:
14.7 N.m (1.5 kgf-m, 10.8 ft-lb)
- Install the water pipe using a new gasket.
Tightening torque:
32 N.m (3.3 kgf-m, 23.6 ft-lb)
- Install the oil pipe (A), water pipe (B) and water hose (C) using new gaskets.
Tightening torque:
T1: 6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
T2: 16 N.m (1.6 kgf-m, 11.8 ft-lb)
T3: 32 N.m (3.3 kgf-m, 23.6 ft-lb)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
