Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Air Cleaner Case: Installation
- Install the cushion.NOTE:
Align the protrusion of the cushion with the cutout portion on the air cleaner case bracket.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the air cleaner case (front).
Tightening torque:
Bolt
6 N.m (0.6 kgf-m, 4.4 ft-lb)
Nut
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the air cleaner element and the air cleaner case (rear). Ref. to INTAKE (INDUCTION) (H4DOTC)>AIR CLEANER ELEMENT>INSTALLATION
- Connect the turbo duct to the air cleaner case (rear).NOTE:
Align the cutout portion on the turbo duct to the protrusion of the air cleaner case (rear).
Tightening torque:
2.5 N.m (0.3 kgf-m, 1.8 ft-lb)
- Connect the connector (A) to the mass air flow and intake air temperature sensor and secure the harness with clip (B).
- Install the air intake duct. Ref. to INTAKE (INDUCTION) (H4DOTC)>AIR INTAKE DUCT>INSTALLATION
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
