Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE
Section 28 (Engine Mechanical System): General Description: Specification: Engine
WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
| Model | 2.4 L | ||||
| Cylinder arrangement | Horizontally opposed, liquid cooled, 4-cylinder 4-stroke gasoline engine |
||||
| Valve system mechanism | Chain driven, double overhead camshaft, 4-valve/cylinder | ||||
| Bore x Stroke | mm (in) | 94.0 x 86.0 (3.70 x 3.39) | |||
| Displacement | cm*3 (cu in) | 2, 387 (146) | |||
| Compression ratio | 10.6 | ||||
| Compression pressure (at 200 - 300 r/min) | kPa (kg/cm2 , psi) | Standard | 1, 350 - 1, 750 (14 - 18, 196 - 254) | ||
| Number of piston rings | Compression ring: 2 Oil ring: 1 |
||||
| Intake valve timing | Open | Max. retard | ATDC 36° | ||
| Min. advance | BTDC 42° | ||||
| Close | Max. retard | ABDC 92° | |||
| Min. advance | ABDC 14° | ||||
| Exhaust valve timing | Open | Max. retard | BBDC 11° | ||
| Min. advance | BBDC 66° | ||||
| Close | Max. retard | ATDC 55° | |||
| Min. advance | ATDC 0° | ||||
| Cam clearance | mm (in) | Intake | Standard | 0.13+0.02-0.03 (0.0051+0.0008-0.0012 ) | |
| Exhaust | Standard | 0.22±0.02 (0.0087±0.0008) | |||
| Idle speed (For CVT model, select lever in "P" or "N" range. For MT model, gear shift lever in neutral position.) | r/min | No load | Standard | 700±100 | |
| A/C ON | Standard | 700 - 880±100 | |||
| Ignition order | 1 → 3 → 2 → 4 | ||||
| Ignition timing | BTDC/{r/min} | Standard | 7°±10°/700 | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
