Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Camera Adjustment, Inspection: Procedure: Notes
- Perform the stereo camera adjustment and inspection without passengers.
- Handle RANDOM CHART carefully so as not to break it with the adhesive force of the tape.
- When [Camera all adjustment mode (replacement/removal)] and [Clear adjustment value] of [Work Support] is pressed mistakenly when the camera adjustment and inspection are not necessarily, select [Cancel] and turn the ignition switch to OFF.
Perform inspection or adjustment according to the following procedures.
- Readjustment of stereo camera
Perform the adjustment in the following order: [1. Preparations] → [4. Camera all adjustment mode (replacement/removal)] → [5. Heater heating and cooling fan drive test] → [6. Automatic adjustment and function check by driving].
- Replacement of stereo camera
Perform the replacement in the following order: [1. Preparations] → [2. Vehicle model information registration] → [3. Adjustment value clear] → [4. Camera all adjustment mode (replacement/removal)] → [5. Heater heating and cooling fan drive test] → [6. Automatic adjustment and function check by driving].
For the necessity of implementation, refer to the flowchart below.
- When the stereo camera or windshield glass has been removed or installed, always perform readjustment of the stereo camera.
- If camera adjustment and inspection are started when the model information is not registered, NG termination will occur because the implementation conditions are not met.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.