Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Radiator Cap: Inspection
- Stop the engine.
- The engine coolant is pressurized when it is hot. Wait until engine coolant cools down before proceeding the work.
- If the engine coolant is spilt over the engine, exhaust pipe or the under cover, completely wipe it off to avoid emission of smoke or causing a fire.
- Remove the radiator cap.
- Check that there is no deformation, cracks or other damages.
- Check the opening pressure of the radiator cap.
- Attach radiator cap tester.
- Increase pressure until the radiator cap tester gauge needle stops. Radiator cap is functioning properly if it holds the service limit pressure for 5 - 6 seconds. Replace the radiator cap if its valve opens at less than the service limit.CAUTION:
Be sure to remove foreign matter and rust from the cap in advance.
Otherwise, results of pressure test will be incorrect.
Specification:
93 - 123 kPa (0.95 - 1.25 kg/cm2 , 14 - 18 psi)
Service limit:
83 kPa (0.85 kg/cm2 , 12 psi)
- Attach radiator cap tester.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
