Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Mt Model
Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
- Install the pedal assembly.
Tightening torque:
18 N.m (1.8 kgf-m, 13.3 ft-lb)
- Install the operating rod to the pedal COMPL brake.
- Install the stop light switch assembly. Ref. to BRAKE>STOP LIGHT SWITCH>INSTALLATION .
- Connect each connector.
- Install the column assembly steering. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>STEERING COLUMN>INSTALLATION .
- Install the universal joint assembly steering. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>UNIVERSAL JOINT>INSTALLATION
.CAUTION:
- Always install the universal joint assembly steering after installing the steering column to avoid damage to the universal joint assembly steering.
- Be sure to follow the tightening order and tightening torque of the universal joint assembly steering to avoid the steering effort from becoming heavy. After confirming that the steering column position is in the neutral position, tighten the universal joint assembly steering.
- Install the duct foot driver. Ref. to AIR CONDITIONER>AIR VENT DUCT>INSTALLATION>FOOT DUCT .
- Install the knee airbag module. Ref. to AIRBAG SYSTEM>KNEE AIRBAG MODULE>INSTALLATION .
- Install the cover LWR driver. Ref. to EXTERIOR/INTERIOR TRIM>INSTRUMENT PANEL LOWER COVER>INSTALLATION .
- Install the bolt and the clutch pipe B to the two-way connector.
Tightening torque:
Flange bolt: 7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
Clutch pipe B: 15.5 N.m (1.6 kgf-m, 11.4 ft-lb)
- Install the reservoir hose assembly.
- Add the recommended brake fluid. Ref. to CLUTCH SYSTEM>CLUTCH FLUID .
- After bleeding air from the clutch system, ensure that no brake fluid leaks and the clutch operates properly. Ref. to CLUTCH SYSTEM>AIR BLEEDING>PROCEDURE .
- Adjust the clutch pedal. Ref. to CLUTCH SYSTEM>CLUTCH PEDAL>ADJUSTMENT .
- Install the intercooler. Ref. to INTAKE (INDUCTION) (H4DOTC)>INTERCOOLER>INSTALLATION .
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
- Check the clutch start system.
- Check that the brake light operate properly.
- Check the brake pedal. Ref. to BRAKE>BRAKE PEDAL>INSPECTION .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
