2021 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Brake Pedal: Disassembly

WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the bolt and nut, and then remove the pedal COMPL brake from the bracket COMPL pedal.
    CAUTION:

    Turn and remove the nut while holding the bolt side. 

    MT model 

    G14602319Courtesy of SUBARU OF AMERICA, INC.
    • CVT model
    G14602320Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the bushing (a), spacer (b), stopper (c) and pedal pad (d) from the pedal COMPL brake.
    • MT model
    G14602321Courtesy of SUBARU OF AMERICA, INC.
    • CVT model
    G14602322Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.