Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE
Brake Pedal: Assembly
WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
- Apply a thin coat of grease to the spacer.
Preparation items:
Grease: NIPPON GREASE NIGTIGHT LTS No. 2 or equivalent
- Install the bushing, spacer, stopper and pedal pad to the pedal COMPL brake.
- Install the pedal COMPL brake to the bracket COMPL pedal.CAUTION:
While holding the bolt side, tighten the nut to the specified torque.
Tightening torque:
30 N.m (3.1 kgf-m, 22.1 ft-lb)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.