2021 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Section 16 (Engine Starting System & Charging System): Generator: Installation

WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Temporarily install the generator.
  2. Tighten the bolts in the numerical order as shown in the figure.

    Tightening torque:Β 

    25 N.m (2.5 kgf-m, 18.4 ft-lb)

    Fig 1: Generator Bolts Tightening Sequence
    G14601641Courtesy of SUBARU OF AMERICA, INC.
  3. Connect the connector (A) and terminal (B).

    Tightening torque:Β 

    15.5 N.m (1.6 kgf-m, 11.4 ft-lb)

    G14601639Courtesy of SUBARU OF AMERICA, INC.
  4. Install the V-belts. Ref. to MECHANICAL (H4DOTC)>V-BELT>INSTALLATION>V-BELT .
  5. Install the air intake duct. Ref. to INTAKE (INDUCTION) (H4DOTC)>AIR INTAKE DUCT>INSTALLATION .
  6. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NO: TE>BATTERY .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.