Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE
Position Is Not Memorized (Automatic Open/Close Cannot Be Performed)
WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
«Position learning»
- Position the lid assembly at the fully tilt up position, and press and hold the tilt up switch for ten seconds.
- The motion of the glass lid shifts to inching operation until it reaches the mechanical lock position (further tilt up position than the fully tilt up position). After the mechanical lock, it returns to the fully tilt up position and then stops.
- Release the tilt up switch to finish the position learning.
«Sliding learning»
- Within six seconds after the position learning is finished, press and hold the tilt up switch again.
- The lid assembly moves to the full close position, full open position, and the full close position successively, and stops at the full close position.
- Release the tilt up switch and turn the ignition switch to OFF to finish the initializing.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
