2021 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

DTC P1C00: Battery Monitor Module "A" Performance: Notes

DTC detecting condition:Β 

Immediately at fault recognition

CAUTION: After servicing or replacing faulty parts, perform Clear Memory Mode. Refer to ENGINE (DIAGNOSTICS) (W/O STI)>CLEAR MEMORY MODE>OPERATION . and Inspection Mode. Refer to ENGINE (DIAGNOSTICS) (W/O STI)>INSPECTION MODE>PROCEDURE .
  1. CHECK DTC.Β 

    Read DTC using the Subaru Select Monitor or a general scan tool.. Refer to ENGINE (DIAGNOSTICS) (W/O STI)>READ DIAGNOSTIC TROUBLE CODE (DTC) .

    Is DTC P1C00 displayed? (Current malfunction)

    Yes:Β  Replace the battery sensor.. Refer to STARTING/CHARGING SYSTEMS (W/O STI)>BATTERY SENSOR .

    No:Β  Even if DTC is detected, it has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.