2021 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Engine Starting System & Charging System (2.0L): Generator: Installation

  1. Temporarily install the generator bracket to the engine and tighten the bolts in the numerical order.

    Tightening torque:Β 

    36 N.m (3.7 kgf-m, 26.6 ft-lb)

    Fig 1: Generator Bracket Bolts Tightening Sequence
    G09476741Courtesy of SUBARU OF AMERICA, INC.
  2. Install the V-belt tensioner assembly. Refer to MECHANICAL(W/O STI)>V-BELT>INSTALLATION>V-BELT TENSIONER ASSY .
  3. Temporarily install the generator bracket to the generator and tighten the bolts in the numerical order.

    Tightening torque:Β 

    25 N.m (2.5 kgf-m, 18.4 ft-lb)

    Fig 2: Generator Bolts Tightening Sequence
    G09476742Courtesy of SUBARU OF AMERICA, INC.
  4. Connect the connector (A) and terminal (B) to the generator.

    Tightening torque:Β 

    15.5 N.m (1.6 kgf-m, 11.4 ft-lb)

    G09476732Courtesy of SUBARU OF AMERICA, INC.
  5. Install the collector cover bracket.

    Tightening torque:Β 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

    G10267432Courtesy of SUBARU OF AMERICA, INC.
  6. Install the V-belts. Refer to MECHANICAL(W/O STI)>V-BELT>INSTALLATION>V-BELT .
  7. Install the brake vacuum pump. Refer to BRAKE>BRAKE VACUUM PUMP>INSTALLATION .
  8. Connect the ground terminal to battery sensor. Refer to NOTE>NOTE>BATTERY .
  9. Install the collector cover. Refer to INTAKE (INDUCTION) (W/O STI)>COLLECTOR COVER>INSTALLATION .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.