2021 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Read Current Data: List

Items to be displayed Unit of measure Content Note
IG on trip number times Time stamp information -
IG on supply system - Time stamp information -
past time after IG on ms Time stamp information -
Fuel level resistance Ω Fuel sensor value display -
Ambient air temperature °C External temperature sensor value display -
Air temperature correction °C Correction value for displaying ambient temperature -
Mean fuel efficiency correction % Correction value for displaying average fuel economy -
Second level belt warning customize 2-stage warning implemented/2-stage warning not implemented Implementation status of seat belt second stage warning -
External air temperature indication value °C Calculated value of external temperature for indication -
Vehicle speed data km/h Vehicle speed value detected by meter -
Engine speed data RPM Engine speed value detected by meter -
Driver side seat belt state Drivers seat seat-belt wearing state/Drivers seat seat-belt non-wearing state Seat belt fastening status -
Passenger side seat belt state Passenger seat seat-belt wearing state/Passenger seat seat-belt non-wearing state Seat belt fastening status -
Rear side (right) seat belt state Rear seat right seat-belt wearing state/Rear seat right seat-belt non-wearing state Seat belt fastening status -
Rear side (center) seat belt state Rear seat center seat-belt wearing state/Rear seat center seat-belt non-wearing state Seat belt fastening status -
Rear side (left) seat belt state Rear seat left seat-belt wearing state/Rear seat left seat-belt non-wearing state Seat belt fastening status -
EPS setting presence state Electric power steering/No Electric power steering Electric power steering equipment status -
R.DIFF oil temperature sensing level °C Rear differential oil temperature sensor value -
Outside temperature for diagnosis °C External temperature sensor value display -
Demonstration mode permission/fault permission Demonstration mode permission/fault permission Demonstration mode permission status -
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.