Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE
Engine Starting System & Charging System (2.0L): Starter: Disassembly
CAUTION:
The starter should be placed through a no-load test whenever it has been overhauled.
- Disconnect the cable from the terminal M of the magnet switch assembly.
- Remove the magnet switch assembly from the starter housing assembly.
- Remove screws (A) of the brush holder assembly, and through bolts (B) on both sides, and remove the starter cover assembly.
- Remove the brush holder assembly from the armature assembly.NOTE: Hold the brush with your fingers so that the brush spring does not come flying out.
- Remove the armature assembly and yoke assembly from the starter housing assembly together as a single unit.
- Separate the armature assembly and yoke assembly.
- Remove the pinion gear from the internal gear assembly.
- Remove seal rubber (A), plate (B), and seal rubber (C).
- Lightly tap the starter housing assembly with a plastic hammer as shown in the figure, and remove the overrunning clutch, internal gear assembly, shaft and shift lever together as one unit.
- Use the following procedures to remove the overrunning clutch from the shaft.
- Use an appropriate tool (such as a fit socket wrench), and remove the stopper from snap ring by lightly tapping the stopper with a plastic hammer.
- Remove snap ring (A) from the shaft, and remove stopper (B).
- Remove the overrunning clutch from the shaft.
- Use an appropriate tool (such as a fit socket wrench), and remove the stopper from snap ring by lightly tapping the stopper with a plastic hammer.
- Separate the internal gear assembly and shaft.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
