Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Window Control Switch: Installation: Sub-Switch
Switch - power window sub front
For installation of the switch - power window sub front on the passenger's seat, refer to the installation procedure of the switch - power window main. Refer to GLASS/WINDOW/MIRRORS>POWER WINDOW CONTROL SWITCH>INSTALLATION>MAIN SWITCH .
Switch - power window sub rear
- Install the panel - power window sub switch rear to the trim panel - rear door.
- Install the trim panel - rear door, Refer to EXTERIOR/INTERIOR TRIM>DOOR TRIM>INSTALLATION .
- Connect the battery ground terminal. Refer to NOTE>NOTE>BATTERY .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.