2021 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Auto Headlight Beam Leveler Control Module: Installation

CAUTION: Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Refer to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
  1. Install the auto headlight beam leveler CONTROL MODULE.
  2. Install the relay & fuse box.

    Tightening torque:Β 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

  3. Install the fuse holder.
  4. Install the knee airbag module. Refer to AIRBAG SYSTEM>KNEE AIRBAG MODULE>INSTALLATION .

    Tightening torque:Β 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

  5. Install the cover assembly - instrument panel LWR driver.
  6. Connect the battery ground terminal. Refer to NOTE>NOTE>BATTERY .
  7. Perform initialization and reinitialization of the auto headlight beam leveler system. Refer to LIGHTING SYSTEM>AUTO HEADLIGHT BEAM LEVELER SYSTEM>PROCEDUREΒ .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.