Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE
Reverse Brake: Disassembly
- Remove the snap ring, and then remove the retaining plate, drive plate, driven plate and dish plate.
- Using the ST and a press, compress the spring retainer to remove the snap ring.
Preparation tool:
ST: COMPRESSOR SPECIAL TOOL (18762AA001)
- Remove the spring retainer.
- Blow compressed air through the hole shown in the figure, and remove the reverse brake piston.
- Remove the D-rings.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.