2021 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE

Oil Pump: Removal

  1. Remove the oil pump chain cover. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580)>OIL PUMP CHAIN>REMOVALΒ .
  2. Set the ST1, ST2, ST3 and ST4 as shown in the figure.
    NOTE: For ST4, use only the shaft.

    Preparation tool:Β 

    ST1: HOLDER (18361AA070)

    ST2: ADAPTER (18362AA080)

    ST3: STANDASSY (18632AA040)

    ST4: SLIDER (18351AA010)

    G13950564Courtesy of SUBARU OF AMERICA, INC.
  3. Attach the ST that was set in step 2.
    NOTE: Be careful not to push in anywhere other than portion (a) of the oil pump.
    G13950565Courtesy of SUBARU OF AMERICA, INC.
    G13950566Courtesy of SUBARU OF AMERICA, INC.
  4. Using the ST, push in the oil pump.
  5. Set a piece of piano wire. (When using as is)
    CAUTION: Be careful not to damage the circlip groove of the converter case.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.