2021 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE

Electric Fluid Pump: Installation

  1. Install a new O-ring.
    NOTE: Apply CVTF to the O-rings.
  2. Install the electric oil pump, and connect the connector.

    Tightening torque:Β 

    22 N.m (2.2 kgf-m, 16.2 ft-lb)

  3. Install the front exhaust pipe. Ref. to EXHAUST (H4DO)>FRONT EXHAUST PIPE>INSTALLATION .
  4. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  5. Perform the air bleeding operation for the electric oil pump.
    CAUTION: Bleed air within 5 minutes.
    1. Remove the filler plug.
      G13950442Courtesy of SUBARU OF AMERICA, INC.
    2. Pour the specified CVTF to the bottom end of filler plug hole.
      CAUTION: Always use specified CVTF. Using fluid other than specified CVTF will cause malfunction.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.