Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE
Shift Control
- Turn the ignition switch to ON.
- While brake pedal is not depressed, check if the select lever does not move from "P" range.
- While brake pedal is depressed, check if the select lever moves from "P" range.
- Set the selector lever to each gear position and check the shifting while driving the vehicle. Operate the paddle shift at manual mode and check the shifting while driving the vehicle.
Selector position Gear position 1st 2nd 3rd 4th 5th 6th 7th 8th D Continuously variable speed change Manual mode OK OK OK OK OK OK OK OK - Set the select lever to other than "P" range. (Model without keyless access with push button start)
- When the ignition switch is turned to OFF, check if the ignition key switch cannot be removed. (Model without keyless access with push button start)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.