2021 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE

Section 5 (Engine Intake System (Induction) And Turbocharger (2.4L)): Intercooler: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Replace the intake duct No. 2 gasket with a new part.
    G13948726Courtesy of SUBARU OF AMERICA, INC.
  2. Install the intercooler stay LH to the intake manifold assembly and install the vacuum pipe assembly stay to the intercooler stay LH.

    Tightening torque:Β 

    T1: 16 N.m (1.6 kgf-m, 11.8 ft-lb)

    T2: 18 N.m (1.8 kgf-m, 13.3 ft-lb)

    Fig 1: Intercooler Stay LH To Intake Manifold Assembly Bolts (With Torque Specification)
    G13948727Courtesy of SUBARU OF AMERICA, INC.
  3. Using a new gasket, set the intercooler and the intake duct No. 3 as a unit.
    G13948728Courtesy of SUBARU OF AMERICA, INC.
  4. Connect the intake duct No. 3 to the intake duct No. 2 and lock it.
    CAUTION:
    • Make sure there are no damage or dust on connections. If necessary, clean the seal surface of the pipe.
    • Confirm that the connections are secure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.