Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Coolant: Inspection
- Stop the engine.
- The engine coolant is pressurized when it is hot. Wait until engine coolant cools down before proceeding the work.
- If the engine coolant is spilt over the engine, exhaust pipe or the under cover, completely wipe it off to avoid emission of smoke or causing a fire.
- Do not use water instead of engine coolant.
Engine coolant:Β
Refer to "SPECIFICATION" for engine coolant. Ref. to COOLING (H4DOTC)>GENERAL DESCRIPTION>SPECIFICATION>ENGINE COOLANT>TYPEΒ .
Engine coolant concentration:
Refer to "SPECIFICATION" for engine coolant concentration. Ref. to COOLING (H4DOTC)>GENERAL DESCRIPTION>SPECIFICATION>ENGINE COOLANT>CONCENTRATIONΒ .
Be sure to use SUBARU Super Coolant, since other coolant may cause corrosion.
- Park the vehicle on a level surface.
- Check the engine coolant amount, and add the engine coolant if the coolant level is low.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
