Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE
Intermediate Case: Assembly
WARNING: This page is about a different variant/trim than selected.
- Install the reverse brake. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>REVERSE BRAKE>ASSEMBLY .
- Install the plugs with new O-rings.NOTE: Apply CVTF to the O-rings.
Tightening torque:
25 N.m (2.5 kgf-m, 18.4 ft-lb)
- Temporarily install the filler plug.NOTE: Replace the filler plug gasket with a new part after adjusting the level of CVTF.
- Install the parking support.
Tightening torque:
25 N.m (2.5 kgf-m, 18.4 ft-lb)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.