2021 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE

Front Differential: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the drive pinion. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>DRIVE PINION>REMOVALΒ .
  2. Remove the lock plate.
    G13951431Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the differential side retainers using the ST.
    NOTE:
    • When the ST interferes with the converter case, align the cutout portion with the interference part.
    • Support the differential case by hand to avoid damaging the retainer mounting bolt hole of the converter case.
    • When there is no replacement of the side bearing inner race, do not confuse the left side and right side.

    Preparation tool:Β 

    ST: WRENCH COMPL RETAINER (18658AA021)

    G13951432Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the differential case.
    CAUTION: Be careful not to damage the attachment section of the differential side retainer.
    G13951433Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the O-rings.
G13951434Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.