Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE
Preparation For Overhaul: Procedure
WARNING: This page is about a different variant/trim than selected.
- After engine has been removed from the vehicle, mount the engine to the engine stand while being careful of the following.
- When mounting the engine stand, follow the instructions of engine stand used.
- When disassembling the cylinder block, remove the crankshaft position sensor plate together with the drive plate first, and then mount the engine stand. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>DRIVE PLATE>REMOVAL .
- Mount the engine stand using the points shown by the arrows in the figure.
CAUTION: Be sure to mount the engine stand at four points. Otherwise, the engine damage may occur.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.