Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE
Cylinder Block: Installation
WARNING: This page is about a different variant/trim than selected.
- Install the cylinder block LH to the engine stand.
- Apply engine oil to the crankshaft bearing, and install the crankshaft bearing to the cylinder block.CAUTION: When performing the operation of the cylinder block RH, be careful of the following.
- Place a wood board wrapped with a waste cloth to prevent the knock pin damage and to stabilize the cylinder block before work.
- Be careful not to scratch the mating surface of cylinder block during work.
- Install new O-rings to the cylinder block LH.
- Apply engine oil to the crankshaft journal, and set the crankshaft to cylinder block LH.
- Apply liquid gasket to the mating surface of cylinder block RH as shown in the figure.CAUTION:
- Place a wood board wrapped with a waste cloth to prevent the knock pin damage and to stabilize the cylinder block before work.
- Be careful not to scratch the mating surface of cylinder block during work.
- Do not let the liquid gasket overflow to the oil passage and crankshaft bearing portions, because the engine seizure may result.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
