2021 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE

Section 1 (Engine Starting System & Charging System (2.4L)): General Description: Specification: Starter

WARNING: This page is about a different variant/trim than selected.
Type Reduction type
Model 438000-4940
Manufacturer DENSO
Voltage and output 12 V - 1.6 kW
Direction of rotation Counterclockwise (when observed from pinion)
Number of pinion teeth 14
No-load characteristics Voltage 11.5 V
Current 100 A or less
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.