Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE
SUBARU Special Tool
| ILLUSTRATION | TOOL NUMBER | DESCRIPTION | REMARKS |
|---|---|---|---|
| - | SUBARU SELECT MONITOR 4 | Used for setting of each function and troubleshooting for electrical system.
NOTE:
For detailed operation procedures, refer to "Help" of application.
|
|
| 18460AA040 | CHECK BOARD | Used for measuring voltage and resistance of TCM terminals. | |
|
18460AA180 | CHECK BOARD | Used for measuring voltage and resistance of ECM terminals. |
|
18460AA150 | CHECK BOARD | Used for measuring voltage and resistance of ECM terminals. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.