Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE
Chain Cover: Removal
NOTE:
When replacing a single part, perform the work with the engine assembly installed to body.
- When working on the vehicleNOTE: When working on the vehicle, perform the following steps also.
- Remove the radiator. Ref. to COOLING (H4DO)>RADIATOR>REMOVAL .
- Drain the engine oil. Ref. to LUBRICATION (H4DO)>ENGINE OIL>REPLACEMENT .
- Remove the V-belt tensioner assembly. Ref. to MECHANICAL (H4DO)>V-BELT>REMOVAL>V-BELT TENSIONER ASSEMBLYΒ .
- Remove the generator. Ref. to STARTING/CHARGING SYSTEMS (H4DO)>GENERATOR>REMOVAL .
- Remove the A/C compressor. Ref. to AIR CONDITIONER>COMPRESSOR>REMOVAL .
- Remove the idler pulley. Ref. to MECHANICAL (H4DO)>V-BELT>REMOVAL>IDLER PULLEYΒ .
- Remove the water pump pulley. Ref. to COOLING (H4DO)>WATER PUMP>REMOVAL>WATER PUMP .
- Remove the crank pulley. Ref. to MECHANICAL (H4DO)>CRANK PULLEY>REMOVALΒ .
- Remove the connector (A) and connector (B).
- Remove the clip (C) securing the engine wiring harness, and place it aside so that it does not interfere with work.
- Disconnect the connector (A) and disconnect the connector (B) from the chain cover.
- Remove the bracket (C) from the water pump.CAUTION: Do not remove the inlet engine coolant temperature sensor harness from the harness stay (C).
- Disconnect the connector (D) and remove the clip (E) securing the oil level switch harness.
- Disconnect the terminal (F), connector (G), connector (H) and connector (I).
- Remove the clip (J) and clip (K) securing the engine wiring harness, and place them aside so that they do not interfere with work.
- Pull out the oil level gauge (A), and remove the oil level gauge guide (B) and crank pulley boss (C).
- Remove the bolts securing the chain cover to the engine.
- Expand the area shown in the figure using a crowbar or a similar tool wrapped in tape for protection, and remove the chain cover from the engine.CAUTION: The chain cover may contact the protrusion (a) of cam sprocket sensor plate and cause damage. When removing the chain cover, move the chain cover horizontally until it cannot contact with the cam sprocket, and then remove it carefully.
- Remove the O-rings from cylinder head RH, cylinder head LH, cylinder block LH and the oil strainer.
- Remove the liquid gasket from the chain cover and engine unit.
- Remove the front oil seal from the chain cover.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
