Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE
Thermo Control Valve Assembly: Removal
- Release the fuel pressure. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>FUEL>PROCEDURE>RELEASING OF FUEL PRESSURE .
- Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
- Drain engine coolant. Ref. to COOLING (H4DO)>ENGINE COOLANT>REPLACEMENT>DRAINING OF ENGINE COOLANTΒ .
- Remove the high-pressure fuel delivery pipe assembly. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>HIGH PRESSURE FUEL DELIVERY PIPE>REMOVAL>HIGH-PRESSURE FUEL DELIVERY PIPE ASSEMBLY .
- Remove the bolt securing the engine ground and the harness case and remove the clip (A), clip (B) and clip (C).
- Remove the connector (A) and connector (B).
- Remove the engine wiring harness stay.
- When thermo control valve assembly is replaced
Remove the bolts that hold the thermo control valve assembly and disconnect the water hose (A), water hose (B), water hose (C) and preheater hose (D) to remove the thermo control valve assembly.
- When thermo control valve assembly is not replaced
- Remove the bolts securing the thermo control valve assembly and disconnect the water hose (A), water hose (B) and water hose (C), and remove them as a unit.CAUTION: Water hoses should not be disconnected unless the thermo control valve assembly is replaced. This may cause damage to the thermo control valve assembly.
- Disconnect the water hose (A), water hose (B), water hose (C) and preheater hose (D) from the thermo control valve assembly.NOTE:
- Perform this procedure only when required.
- To avoid excessive load to the thermo control valve assembly during removal, cut through the hoses.
- Remove the bolts securing the thermo control valve assembly and disconnect the water hose (A), water hose (B) and water hose (C), and remove them as a unit.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
