Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE
Magnet Switch Operation
CAUTION:
Perform the inspection in a short period of time. (Within 3 to 5 seconds)
- Loosen the nut which holds the cable to the M terminal.NOTE: This procedure is required to facilitate the cable removal from the M terminal.
- Connect the battery positive terminal to the S terminal, and connect the battery negative terminal to the starter housing. Then, if the pinion protrudes, it is normal.NOTE: The motor may rotate while the pinion protrudes. This occurs due to current that flows to the motor via pull-in coil. This is not a problem.
- Disconnect the cable from the M terminal. Check that the pinion is being protruded at this time.CAUTION: Hold the disconnected cable so that it does not contact the terminal or wiring.
- Disconnect the battery negative terminal from the starter housing. Then, if the pinion returns to its original position, it is normal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
