2021 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE

Parking Brake System: General Description: Caution

  • When performing service operation, refer to "Repair Contents" in "General Description". Ref. to REPAIR CONTENTS>REPAIR CONTENTS .
  • When performing any work, always wear work clothes, a work cap and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.
  • When performing a repair, identify the cause of trouble and avoid unnecessary removal, disassembly and replacement.
  • Some vehicle components are extremely hot immediately after driving. Be wary of receiving burns from heated parts.
  • Use SUBARU genuine grease, the recommended or equivalent. Do not mix grease etc. of different grades or manufacturers.
  • Be sure to tighten fasteners including bolts and nuts to the specified torque.
  • Always use the jack-up point when the shop jacks or rigid racks are used to support the vehicle.
  • Apply grease onto sliding or revolving surfaces before installation.
  • Be sure that the surface of brake disc and brake pad is free from grease or oil.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.