2021 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE

Data Monitor: List

Item Content/display range Standard Note
Trip Count [count] Time stamp information Ref. to COMMON (DIAG)>TIME STAMP . Time -
Count - -
Time Count ms -
Battery Voltage Battery voltage 0 - 32 V -
Ignition Signal(Line) Condition of ignition power supply (direct line) ON: Switch ON
OFF: Switch OFF
Keyless entry control module, always OFF
Ignition Signal (CAN) Condition of ignition power supply (CAN communication) ON: Switch ON
OFF: Switch OFF
-
Number of Registered Keys Number of registered keyless entry 0 - 4 -
Max Number of Register Keys Maximum number of registered keyless entry 0 - 4 -
Key-lock Warning SW Key warning switch status ON: Switch ON
OFF: Switch OFF
-
Power Saving Mode Electricity save mode condition Normal: Normal
Brownout: Saving
-
Keyless ID Registration Mode Registration mode condition Normal: Normal
Factory Reg: Factory registration mode
Dealer Reg: After market registration mode
Delete: Delete mode
-
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.