2021 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE

Power Rear Gate System: General Description: Caution

  • When performing service operation, refer to "Repair Contents" in "General Description". Ref. to REPAIR CONTENTS>REPAIR CONTENTS .
  • Before disconnecting connectors of sensors or units, be sure to disconnect the ground terminal from the battery sensor.
  • When replacing the parts provided with memory functions, record the memory contents before disconnecting the ground terminal from the battery sensor.
  • Disconnecting the ground terminal from the battery sensor may make manual open/close operation of the rear gate difficult.
  • This is because the open/close operation of the rear gate activates the brake mechanism for system protection of the power rear gate to prevent damage to the power rear gate control module.
  • After reassembly, close the rear gate and then connect the ground terminal to the battery sensor. Initialization of the power rear gate auto closer is necessary, when connection is performed with the rear gate open. Ref. to POWER REAR GATE SYSTEM>POWER REAR GATE SYSTEM>PROCEDURE>INITIALIZATIONΒ .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.