2021 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE

Inspection Mode 2

DTC Description and trouble part Note
B2604 Power Seat Memory EEPROM -

Diagnostic procedure:

  1. Using the Subaru Select Monitor, perform the clear memory of [Power Seat Memory]. Ref. to COMMON (DIAG)>CLEAR MEMORY .
  2. Using the Subaru Select Monitor, read the DTC of [Power Seat Memory] to check that there is no DTC displayed. Ref. to Power Seat Memory System (Diagnostics)>Diagnostic Trouble Code (DTC)Β .
    NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs. After solving the DTC, repeat from step 1).
  3. Initialize the power seat system. Ref. to SEATS>POWER SEAT SYSTEM .
  4. Turn the ignition switch ON β†’ OFF, and wait for 45 seconds or more.
  5. Turn the ignition switch OFF β†’ ON, and wait for 5 seconds or more.
  6. Using the Subaru Select Monitor, read the DTC of [Power Seat Memory] to check that there is no DTC displayed. Ref. to Power Seat Memory System (Diagnostics)>Diagnostic Trouble Code (DTC)Β .
    NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.