2021 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE

Display Assembly

CAUTION: Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM".
  1. Install the data communication module. Ref. to DATA COMMUNICATION MODULE .
  2. Install the backup unit assembly. Ref. to SECURITY AND LOCKS>BACKUP UNIT>INSTALLATION .
  3. Install the center information display assembly.
    CAUTION: Do not allow the harnesses and cords to interfere with or get caught by other parts.

    Tightening torque: 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

  4. Install the ornament panel mid passenger.
  5. Install the cover assembly front. Ref. to EXTERIOR/INTERIOR TRIM>CONSOLE BOX>INSTALLATION .
  6. Install the grip and boot. Ref. to CONTROL SYSTEMS>SELECT LEVER>INSTALLATION .
  7. Install the driver monitoring unit assembly or the cover center UPR. Ref. to INSTRUMENTATION/DRIVER INFO>DRIVER MONITORING UNIT>INSTALLATION .
  8. Install the visor assembly. Ref. to INSTRUMENTATION/DRIVER INFO>COMBINATION METER>INSTALLATION .
  9. Install the cover LWR driver. Ref. to EXTERIOR/INTERIOR TRIM>INSTRUMENT PANEL LOWER COVER>INSTALLATION .
  10. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
    NOTE: After connecting the ground terminal to the battery sensor, place the select lever in the "P" position.
Chapter Navigation
Return to Chapter: Installation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.