2021 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE

Cockpit Display: Disassembly

  1. Remove the center information display.
    1. Release the clips and disconnect the connectors.
      G13952074Courtesy of SUBARU OF AMERICA, INC.
    2. Remove the screws and remove the center information display.
      NOTE: Remove the screws on LH side in the same procedure as on the RH side.
      G13952075Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the switch hazard. Ref. to LIGHTING SYSTEM>HAZARD SWITCH>REMOVAL .
  3. Disconnect the connectors, and remove the cord assembly.
    G13952076Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the screws and remove the unit bracket from the cockpit control module.
    NOTE: Remove the screws on LH side in the same procedure as on the RH side.
    G13952077Courtesy of SUBARU OF AMERICA, INC.
Chapter Navigation
Return to Chapter: Cockpit Display
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.