Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru Legacy BaseFACTORY OEM SERVICE PROCEDURE
Rear Toe-In
When adjusting, adjust it to the following value.
Toe-in: Adjustment value
0±2 mm (0±0.08 in)
- Loosen the self-locking nut while holding the bolt side of rear lateral link assembly front.
- Turn the adjusting bolt until toe-in is within the specification.NOTE: When the left and right wheels are adjusted for toe-in at the same time, the movement of one scale graduation changes toe-in by approx. 6 mm (0.24 in).
To increase toe-in. Rotate the left side clockwise. Rotate the right side counterclockwise. To decrease toe-in. Rotate the left side counterclockwise. Rotate the right side clockwise. - Attach and tighten a new self-locking nut.CAUTION: While holding the bolt side, tighten the nut to the specified torque.
Tightening torque:
120 N.m (12.2 kgf-m, 88.5 ft-lb)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.