2021 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE

Select Lever: Installation

  1. Install the select cable. Ref. to CONTROL SYSTEMS>Select Cable>INSTALLATION .
  2. Install the select lever.

    Tightening torque: 

    18 N m (1.8 kgf-m, 13.3 ft-lb)

  3. Connect the connector.
  4. Install the harness.
  5. Install the duct console center. Ref. to AIR CONDITIONER>AIR VENT DUCT>INSTALLATION>CONSOLE DUCT>CENTER .
  6. Install the clamp.
    NOTE: Insert it from the front side.
  7. Install the grip.
    NOTE: Install it while pressing on the clamp.
  8. Install the boot. (Model with boot shifter)
  9. Install the grip cover. (Model with gate shifter)
  10. Connect the select cable to the transmission main body.
    CAUTION: Do not apply excessive load while holding the part (a).
    G13591814Courtesy of SUBARU OF AMERICA, INC.
    NOTE: Set the washer before installing the snap pin.

    Tightening torque: 

    25 N m (2.5 kgf-m, 18.4 ft-lb)

    G13225470Courtesy of SUBARU OF AMERICA, INC.
  11. Adjust the select cable free play. Ref. to CONTROL SYSTEMS>Select Cable>ADJUSTMENT .
  12. Install the center exhaust cover.

    Tightening torque: 

    18 N m (1.8 kgf-m, 13.3 ft-lb)

  13. Shift the select lever to "P range".
  14. Connect the ground terminal to battery sensor. Ref. to GROUND TERMINAL REMOVAL OR INSTALLATION .
Chapter Navigation
Return to Chapter: Select Lever
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.