2021 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE

Transmission Harness: Removal

  1. Remove the transmission body, Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580)>Transmission Assembly>REMOVALΒ .
  2. Remove the air breather hose. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580)>Air Breather Hose>REMOVALΒ .
  3. Disconnect the connector and ground terminal as shown in the figure, and release the clips.
    G13869305Courtesy of SUBARU OF AMERICA, INC.
    G13869306Courtesy of SUBARU OF AMERICA, INC.
    G13869307Courtesy of SUBARU OF AMERICA, INC.
  4. Disconnect the transmission harness from the control valve body, Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580)>Control Valve Body>REMOVALΒ .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.