Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE
Reverse Brake: Inspection
- Check that there is no deformation, cracks or other damages.
- Check the driven plate for discoloration (burnt color).
- Make sure the clearance between retaining plate and snap ring of reverse brake is within the limit.NOTE: If it exceeds the limit, replace with a new drive plate and select and adjust the retaining plate within the standard value. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580)>Reverse Brake>ASSEMBLY .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.