2021 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE

Reduction Driven Gear: Adjustment

  1. Measure the height "A" from the ST upper face to the ball bearing catch surface.

    Preparation tool:Β 

    ST: GAUGE (499575600)

    G08317941Courtesy of SUBARU OF AMERICA, INC.
  2. Measure the height "B" from the ST to the mating surface of the transmission case.

    Preparation tool:Β 

    ST: GAUGE (499575600)

    G11255795Courtesy of SUBARU OF AMERICA, INC.
  3. Obtain the thickness of transfer drive gear shim using the following formula to select one to three transfer drive gear shims.

    T mm = A - B - (0.05 - 0.25)

    [T in = A - B - (0.002 - 0.01)]

    T: Shim thickness

    A: Height from the ST upper face to the ball bearing catch surface

    B: Height from ST to transmission case mating surface

    0.05 - 0.25 mm (0.002 - 0.01 in): Clearance

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.