2021 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE

Reduction Drive Gear: Adjustment

  1. Remove the reduction drive gear shim.
  2. Install the transmission case, and secure it with four or five bolts.

    Tightening torque:Β 

    22 N.m (2.2 kgf.m, 16.2 ft.lb)

  3. Measure depth "A" from the ST upper face to the reduction drive gear end face.

    Preparation tool:Β 

    ST: GAUGE (499575400)

    G08317984Courtesy of SUBARU OF AMERICA, INC.
  4. Raise and hold the reduction drive gear.
    G08317985Courtesy of SUBARU OF AMERICA, INC.
  5. Measure depth "B" from the ST upper face to the reduction drive gear end face.

    Preparation tool:Β 

    ST: GAUGE (499575400)

    G08317986Courtesy of SUBARU OF AMERICA, INC.
  6. Obtain the thickness of reduction drive gear shim using the following formula to select one to three reduction drive gear shims.

    T mm = A - B - (0.05 - 0.25)

    [T in = A - B - (0.002 - 0.01)]

    T: Reduction drive gear shim thickness

    A: Depth from the ST upper face to the reduction drive gear end surface

    B: Depth from the ST upper face to the reduction drive gear end surface

    0.05 - 0.25 mm (0.002 - 0.01 in): Clearance

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.