2021 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE

Forward Clutch: Adjustment

  1. Install the thrust bearing to the internal gear.
    NOTE: Make sure to install in the right direction.
    G08318061Courtesy of SUBARU OF AMERICA, INC.
  2. Measure depth "A" from the ST upper face to the washer mounting surface.

    Preparation tool:Β 

    ST: GAUGE (499575600)

    G08318080Courtesy of SUBARU OF AMERICA, INC.
  3. Measure the height "B" from the ST upper face to the mating surface of the drive pinion retainer.

    Preparation tool:Β 

    ST: GAUGE (499575600)

    G08318081Courtesy of SUBARU OF AMERICA, INC.
  4. Calculate the following formula.

    T mm = A - B - (0.35 - 0.70)

    [T in = A - B - (0.014 - 0.028)]

    T: Washer thickness

    A: Depth from the ST upper face to the washer mounting surface

    B: Height from ST upper face to the drive pinion retainer mating surface

    0.35 - 0.70 mm (0.014 - 0.028 in): Clearance

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.