2021 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE

Seat Memory Control Module Diagnostics And New Part Availability (07-185-20R)

Publication date: 2021-03-10
Reference number: 07-185-20R
Supersedes refnos: 07-185-20

SEAT MEMORY CONTROL MODULE DIAGNOSTICS AND NEW PART AVAILABILITY

SEAT MEMORY CONTROL MODULE DIAGNOSTICS AND NEW PART AVAILABILITY

TECHNICAL SERVICE BULLETIN

Reference Number(s): 07-185-20R, Date of Issue:  March 10, 2021
SUBARU: 2019-21 Forester

APPLICABILITY

2019-21MY Forester

INTRODUCTION

This bulletin provides additional diagnostics and new part availability information for the Seat Memory Control Module. In some cases, the seat memory function may either not operate when the customer attempts to have the seat automatically return to their selected preset positions or, not allow any seat position presets to be stored for future use. In addition, the customer may experience difficulty with registering a profile into the Driver Monitor System. The control logic of the control module has been revised to prevent these conditions.

PRODUCTION CHANGE INFORMATION

The new seat memory module was incorporated into production starting with VIN MH417117. 

PART INFORMATION

The part number for the new seat memory module is 64122SJ001  .

REMINDER  : Always order the most up-to-date replacement parts based on the specific VIN being repaired.

SERVICE PROCEDURE/INFORMATION

REMINDER  : Customer satisfaction and retention starts with performing quality repairs.

The service procedures for seat memory control module replacement remain unchanged although diagnostic will be corrected in the applicable Service Manual soon. Always review the full requirements of the repair being performed before proceeding. Service Manual procedures contain information critical to performing an effective repair the first time, every time. This includes but is not limited to important SAFETY precautions, proper inspection criteria, necessary special tools, required processes and related one-time-use parts needed for a complete and lasting repair.

The illustration below shows a portion of the current Service Manual diagnostic procedure related to this repair. The highlighted text box contents in red will be added to the Service Manual diagnostics.

G13117023
IMPORTANT: Whenever the seat memory control module is replaced, the initialization/calibration procedure supplied below MUST  be completed successfully.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.